Basic Key Setting Operations - Sony DVS-7250 Operation Software

Saving and recalling default values of parameters
You can make default values of key parameter settings saved in memory for a
particular combination of signal selected as the key source on an M/E bank or
the DSK block, keyer, and key type.
Use a setup menu to save the values (see page 14-32).
To recall the default values for M/E-1 key 1, for example, select the signal as
key source with the M/E-1 KEY 1 menu displayed on screen, and hold down
the function key for the required key type.
Resetting all of the key modifiers to the default settings
It is possible to reset all of the key modifiers, including key invert, key edge,
and key mask to the default settings.
To turn off the key modifiers, hold down the top menu button corresponding
to the keyer on which execution is to occur. For example, for M/E-1 keyer 1,
hold down the KEY 1 button in the M/E-1 group in the menu control block.
You can determine the default settings using a setup menu operation.
For more information about the default settings, see the section on the
BACKUP menu (page 14-14).

Basic Key Setting Operations

This section describes the basic menu operations for key settings for the M/E
and PGM/PST banks.
Key setting menus
The key setting menus are listed in the following table.
Bank
M/E-1
M/E-2
PGM/PST
Keyer Menu
key 1 M/E-1 KEY1
key 2 M/E-1 KEY2
key 1 M/E-2 KEY1
key 2 M/E-2 KEY2
DSK 1 DSK 1
DSK 2 DSK 2
Chapter 4 Basic Operations for Image Creation
4-37