Starting A Capture; Manually Stopping A Capture - AEMC 8335 Power Pad User Manual

2. Select the Start threshold field using the ▲ and ▼ buttons. The selected field
is highlighted in yellow. Press
Use the ▲ and ▼ buttons to increase or decrease a value and press ◄ and ►
buttons to switch to the next value field.
3. Press
Proceed in the same manner for the Triggering filter, Hysteresis and Start fields.
Note: For more information on the hysteresis, refer to Appendix A: Mathematical
Formulas.

5.1.2.2 Starting a Capture

To start the capture at the defined start date and time defined previously, press the
yellow button corresponding to the OK icon.
The OK icon disappears and the
•
• When the activation conditions are met and the start time is reached,
the message Capture pending is displayed and the memory indicator
appears at the top of the screen.
The indicator is displayed only during the capture and disappears when the
•
capture is completed.
• If the capture is completed with a stop event or if the memory is full, the
capture stops automatically. The Capture Schedule screen with the OK
icon (bottom right of screen) is displayed again.
The PowerPad
memory. If you wish to make another capture, delete the previous one
first.
To return to the Waveform Capture screen, press

5.1.2.3 Manually Stopping a Capture

The capture can be manually stopped by pressing the
OK icon will reappear in the same location.
Shop for AEMC products online at:
Power Quality Analyzer Model 8335
to confirm programming of the activation threshold.
can keep only a single current waveform capture in
®
PowerMeterStore
www.
to enter the type of values.
icon appears instead.
.
icon's yellow button. The
1.877.766.5412
.ca
55