Table of Contents
Advertisement
6.5.4 Recordings Configuration
The Recordings tab shows the parameters for a recording session.
Four different configurations are available. More configurations can be saved by
pressing "Save to File" and recalled later by pressing "Load From File".
1.
Select the configuration to set up: 1, 2, 3 or 4.
Check the box for each parameter desired in the "Data to Record" section.
2.
3.
Configure the harmonic values to be recorded, if desired.
It is possible to record up to 2 of 4 types of harmonic data, voltage
(Vh), current (Ah), phase to phase voltage (Uh), and power (VAh).
For each selected harmonic data type, you can choose a range of harmonics
to record from the 1st to 50th. You can further limit that range to only include
odd numbers by checking the box for "Odd Harmonics Only".
4.
Check the box next to "Schedule Recording" to activate the recording func-
tion. Choose a starting and ending time to assign a time period for the record-
ing to run. Enter a name for the recording (up to 8 characters), if desired.
5.
Choose an "Averaging Period" for the recording, which sets how often the
recording updates while it is running.
Shop for AEMC products online at:
Power Quality Analyzer Model 8335
Figure 6-9
PowerMeterStore
www.
1.877.766.5412
.ca
101
Advertisement
Table of Contents
