Recording Modes; Waveform Capture Mode; Transient Mode - AEMC 8335 User Manual

To select parameters in all modes, use the ◄ ►▲▼ buttons to move to the desired
parameter and use the

6.1 Waveform Capture Mode

Press the waveform display mode button. The Waveform Capture screen appears
with two submenus. Select either the Transient mode (§ 6.1.1) or the Inrush
Current mode (§ 6.1.2) using the ▲ and ▼ buttons, then confirm with
To return to the Waveform Capture screen, press

6.1.1 Transient Mode

This mode enables transients to be recorded, the list of recorded transients to
be viewed, and if necessary, deleted. All tracks are stored in memory for each
transient (regardless of the connection configuration). You can record up to 300
transients.
NOTE: When the Transient mode is selected, the display screen will depend on
the following conditions:
if ...
no record has been made
transients have been recorded
Power Quality Analyzer Model 8335
CHAPTER 6

RECORDING MODES

button to confirm selections.
Figure 6-1
then ...
the Detection Schedule screen is displayed
the Recording List screen is displayed
.
.
51