To select parameters in all modes, use the ◄ ►▲▼ buttons to move to the desired
parameter and use the
5.1 Waveform Capture Mode
Press the Waveform Display mode
appears with two submenus.
Select either the Transient mode (§ 5.1.1) or the Inrush Current mode (§ 5.1.2)
using the ▲ and ▼ buttons, then confirm with
To return to the Waveform Capture screen, press
5.1.1 Transient Mode
This mode enables transients to be recorded, the list of recorded transients to
be viewed, and if necessary, deleted. All tracks are stored in memory for each
transient (regardless of the connection configuration). You can record up to 210
transients.
NOTE: When the Transient mode is selected, the display screen will depend on
the following conditions:
if ...
no record has been made
Shop for AEMC products online at:
transients have been recorded
50
CHAPTER 5
DISPLAY MODES
button to confirm selections.
button. The Waveform Capture screen
Figure 5-1
then ...
PowerMeterStore
the Detection Schedule screen is displayed
www.
the Recording List screen is displayed
.
.
.ca
Power Quality Analyzer Model 8335
1.877.766.5412