Table of Contents
Advertisement
4.1.2.2 STARTING A CAPTURE
As noted in the preceding table, you can press the
current threshold is set to 0A and the hysteresis is 100%. To start the capture at a previously specified date and time,
press the
button. The icon on the status bar blinks to indicate that the capture has been started. The
replaces the
button and can be used to stop the capture before it is finished.
● When the activation conditions are met and the start time is reached, the message Capture pending is displayed
and the memory indicator appears at the top of the screen.
● The indicator is displayed only during the capture and disappears when the capture is completed.
● If the capture is completed with a stop event or if the memory is full, the capture stops automatically. The Capture
Schedule screen with the
The Model 8435 can keep only a single Inrush capture in memory. If you want to make another capture, delete the previous one
first.
To return to the Waveform Capture screen, press
4.1.2.3 MANUALLY STOPPING A CAPTURE
The capture can be manually stopped by pressing the
location.
4.1.2.4 DISPLAYING THE PARAMETERS OF A CAPTURE
In capture display mode, two sub-menus RMS and PEAK are available. To display the parameters of a capture, proceed
as follows:
1. Select the sub-menu by pressing the
2. Choose the type of display, RMS or PEAK, by pressing the yellow button corresponding to the icon. The Model 8435
displays curves on which you can move the time cursor and zoom in and out.
In the PEAK display, the available information is:
● The instantaneous current and voltage at the time indicated by the cursor (in a "waveform" representation).
● The maximum instantaneous current and voltage in the half-cycle indicated by the cursor (in an "envelope"
representation).
● The maximum instantaneous absolute value of the current and voltage (over the entire capture).
40
Find Quality Products Online at:
button to start a recording immediately. When you do this, the
button displayed again.
.
icon's yellow button. The
icon's yellow button. The Capture Parameters screen is displayed.
Figure 4-7
GlobalTestSupply
www.
button will reappear in the same
Power Quality Analyzer PowerPad
.com
sales@GlobalTestSupply.com
button
®
III Model 8435
Advertisement
Table of Contents
