Recording Data; Starting A Recording Session; Stopping A Recording Session; Downloading Recorded Data - AEMC 607 User Manual

4.17 RECORDING DATA

4.17.1 Starting a Recording Session

NOTE:
A new recording cannot be started if the memory is full or if the
Bluetooth is active.
1. Configure the instrument as described in § 4.4.
2. Select the measurement function to be recorded using the rotary switch
and connect the instrument to the measurement source.
3. Press the REC button for > 2 sec to start a recording.
4. The REC indication will remain solid when there is available memory or
it will blink if the memory is full.
5. If the memory is partially full then it is possible to start another
recording. The duration of the recording will depend on the available
memory.

4.17.2 Stopping a Recording Session

1. Press and hold the REC button for > 2 secs.
2. The REC indication will not be displayed if a recording is not active.

4.18 DOWNLOADING RECORDED DATA

Recorded measurements stored in the instrument are transferred to a computer
via the download command in the DataView

4.19 ERASING DATA FROM MEMORY

Erasing data from the instrument's memory can be performed in two ways.
Erasing Memory using the
1. Turn the instrument OFF.
2. Press and hold the
Ω
position.
3. Release the
memory.
Erasing Memory using the DataView
1. Connect the instrument to the computer and launch the PowerPad
Control Panel. (NOTE: this is different from the PowerPad III Control
Panel.)
2. Select View Recorded Data from the Instrument menu.
3. In the Recorded Data in Instrument window, select the Select All
button and click on Delete All to erase the memory.
Clamp-On Meter Model 607- User Manual
®
button and rotary switch:
button while rotating the rotary switch to the
button when RST REC is displayed to erase the
PowerPad Control Panel:
®
PowerPad Control Panel.
49