Recording Data; Starting A Recording Session - AEMC SIMPLE LOGGER II User Manual

The instrument contains protection circuitry to prevent it from being turned
on when the battery voltage is below 1.7V.
There are two thresholds for the battery voltage:
• The first is used to indicate low battery. The low battery indicator will
blink when the battery voltage drops below 1.8V.
• The second is used to determine when to terminate recording and
turn the unit off. The shutdown threshold is when the battery voltage
drops below 1.7V.
4.4

Recording Data

NOTE: The Simple Logger
the users needs (see the Configuring the Simple Logger
DataView
Once a configuration is written to the instrument, the logger will no longer
need to be connected to DataView
When data is stored in the memory, the user may download the informa-
tion onto a hard-disk (see the Downloading Recorded Instrument Data
section inside the DataView
4.4.1

Starting a Recording Session

NOTE: A new recording cannot be started if the memory is full.
1. Connect the instrument to the measurement source.
2. Make sure the logger is in STANDBY mode (see § 4.3).
3. Press and hold the PRESS button. When the START (GREEN) LED
lights up, release the button.
4. Verify that the GREEN LED double-blinks to ensure that the logger is
recording.
®
Simple Logger II Model L261
®
®
user manual).
®
II is factory configured and may be altered to fit
to start the configured recording.
®
user manual).
® II section inside the
13