Maintenance; Battery Indicator - AEMC 8335 Power Pad User Manual

Use only factory specified replacement parts. AEMC
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.
Before first use, charge and discharge the instrument one or two cycles
to ensure the proper level display of the battery indicator.

7.1 Battery Indicator

The number of bars in the battery icon located in the upper right of the screen
shows the battery level.
Icon
When the capacity of the battery is too low, the following message is displayed:
Press to confirm. The PowerPad
connect the PowerPad
The battery may fully discharge when recording for long periods of time
while not connected to a power supply. The PowerPad
record for some time, even if below the minimum battery charge value.
However, the display may not come back on, and will eventually stop
saving data when the battery is too low. All data recorded will be saved.
During the recording, the ON/OFF button will blink. If the light is not blink-
ing, the recording has stopped and the data has been saved. Do not turn
the instrument OFF. Supply power to the PowerPad
and press the ON/OFF button.
Shop for AEMC products online at:
Power Quality Analyzer Model 8335

MAINTENANCE

Battery charged
Low battery
Battery charging
The PowerPad is being powered by the power cord
®
Instrument will soon turn OFF
to the power cord.
®
PowerMeterStore
www.
CHAPTER 7
Battery Charge Status
Low battery
will shut off after one minute if you do not
®
will not be held responsible
®
will continue to
®
with the power cord
®
1.877.766.5412
.ca
111