Table of Contents
Advertisement
4.3.7 Transient Mode Configuration
The
mode is used to configure the voltage and current thresholds.
4.3.7.1 Current Thresholds
A first screen defines the current thresholds for each current sensor recognized.
The thresholds programmed can be the same for all channels or different for some
or all of them.
An example of programming of four independent thresholds:
To program the current threshold for the search for a transient, proceed as follows:
•
Select the Configuration of thresholds field, highlighted in yellow, by pressing
The arrows appear in the field.
•
Use the ▲ or ▼ key to go from one type of configuration to another.
•
Press
to validate the choice of configuration.
•
Select the field of the first threshold using the ▲ or ▼ key. The selected field
is highlighted in yellow. Press
field.
•
Use the ▲ or ▼ key to increment or decrement a value and ◄ or ► to go to the
next item.
•
Press
to validate the programming of the threshold.
It is possible to configure the current thresholds in mA, A, or kA.
Shop for AEMC products online at:
44
Figure 4-11
to enter the values. The arrows appear in the
PowerMeterStore
www.
.ca
Power Quality Analyzer Model 8335
.
1.877.766.5412
Advertisement
Table of Contents
