Recording Data; Starting A Recording Session; Stopping A Recording Session; Downloading Recorded Data - AEMC CL601 User Manual

4.4

Recording Data

NOTE: The Simple Logger
the users needs (see the Configuring the Simple Logger
DataView
Once a configuration is written to the instrument, the logger will no longer
need to be connected to DataView
When data is stored in the memory, the user may download the informa-
tion onto a hard-disk (see the Downloading Recorded Instrument Data
section inside the DataView
4.4.1

Starting a Recording Session

NOTE: A new recording cannot be started if the memory is full.
1. Connect the instrument to the measurement source.
2. Make sure the logger is in STANDBY mode (see § 4.3).
3. Press and hold the PRESS button. When the START (GREEN) LED
lights up, release the button.
4. The GREEN LED double-blinks when the logger is recording.
4.4.2

Stopping a Recording Session

1. Press and hold the PRESS button. When the STOP (ORANGE) LED
lights up, release the button.
2. The GREEN LED will change from a double-blink to a single-blink,
indicating STANDBY mode.
The data will be retained, even if the instrument is turned OFF. The
recorded data is stored in Flash memory (maintained even in the absence
of batteries). The recorded data may be downloaded to a computer.
4.5

Downloading Recorded Data

Recorded measurements stored in the instrument are transferred to
a computer via the download command in the SLII Control Panel. For
instructions on downloading data, see the Downloading Recorded Instru-
ment Data section inside the DataView
Simple Logger II Model CL601
®
Shop for AEMC products online at:
II is factory configured and may be altered to fit
®
user manual).
®
user manual).
®
ShopAEMC
www.
to start the configured recording.
®
manual.
®
.com
II section inside the
®
13
1.888.610.7664