Capture Mode; Transient Voltage Thresholds - AEMC PowerPad III 8336 User Manual

4.1.6 CAPTURE MODE

The Capture mode is used to configure the voltage thresholds, the current thresholds of the transient mode, and the
current thresholds of the inrush current mode.

4.1.6.1 TRANSIENT VOLTAGE THRESHOLDS

The first Thresholds screen, displayed by pressing the V icon (or U, for set-ups without a neutral), configures the
voltage thresholds. These thresholds can be the same for all channels or different for some or each of them.
To change the voltage thresholds, press
Use the ▲ and ▼ buttons to choose configuration of the thresholds.
■ 4V or 3U: all channels have the same threshold.
- Press the
- Press the
■ 3V + VN: all channels have the same ratio and the neutral has a different ratio. Proceed as when there is only one
ratio, but perform the operation twice.
■ V1+V2+V3+VN or U1+U2+U3: each channel has a different ratio, to be programmed. Proceed as when there is only
one ratio, but perform the operation several times.
Confirm your selections by pressing
NOTE: You cannot modify thresholds in the transient mode if the instrument is searching for transients.
Power Quality Analyzer PowerPad
.
button, then use the ▲ and ▼ buttons to highlight the value of the threshold in yellow.
button, then use the arrow buttons to change the threshold. The unit can be V or kV.
. To return to the Configuration menu, press
III Model 8336
®
Figure 4-16
.
31