Instrument Configuration (Set-Up Mode) - AEMC 6470-b User Manual

• When the measurement results are acceptable, stop the measurement by
• View the result on the display and toggle through the relevant parameters
• To record the information into memory, use the MEM button (see § 7).

4.2 Instrument Configuration (SET-UP mode)

To configure the Model 6470-B parameters, turn the rotary switch to SET-UP:
• All the segments on the display are activated for 1 second and then the
• Various parameters are accessible by pressing the corresponding button.
• The number or symbol which can be modified flashes. These are changed
• To exit SET-UP, turn the rotary switch to another position.
• All of the parameters that are modified are permanently saved until a new
Parameter to be modified
Distance unit
Alarm (for mΩ and 2-wire
measurements only)
Buzzer
Modbus address
Date
Time
Baud
Default configuration
Memory used
*International format date and time only
Ground Resistance Tester Model 6470-B
uality Products Online at:
pressing the START/STOP button.
using the DISPLAY button.
"PUSH button" message appears on the display.
using the SELECT button [►] and CHANGE buttons [▲▼].
instrument configuration is performed.
GlobalTestSupply
www.
Button
DISPLAY (1 press)
st
DISPLAY (2 press)
nd
DISPLAY (3 press)
rd
DISPLAY (4 press)
th
Hz/OPTIONS (1 press) yyyy.mm.dd*
st
Hz/OPTIONS (2 press) hh : mm*
nd
Hz/OPTIONS (3 press) 9.6k / 19.2k / 38.4k
rd
Hz/OPTIONS (4 press) yes / no
th
MEM (1 press)
st
Possible values
m (meter) or ft (feet)
ON / OFF
direction (< or >)
value (1 to 999Ω)
ON / OFF
1 to 247
000 to 512 (total
number of locations)
.com
sales@GlobalTestSupp
Default values
m
OFF
>
2Ω
ON
1
Current date*
Current time*
9.6 k bits
yes
000 on 512
23