Configuring Dynamic-Access Ports On Vmps Clients - Cisco Catalyst 2960 series Configuration Manual

How to Configure VMPS

Configuring Dynamic-Access Ports on VMPS Clients

Dynamic-access port VLAN membership is for end stations or hubs connected to end stations. Connecting
Caution
dynamic-access ports to other switches can cause a loss of connectivity.
If you are configuring a port on a cluster member switch as a dynamic-access port, first use the rcommand
privileged EXEC command to log in to the cluster member switch.
Before You Begin
You must have IP connectivity to the VMPS for dynamic-access ports to work. You can test for IP connectivity
by pinging the IP address of the VMPS and verifying that you get a response.
To return an interface to its default configuration, use the default interface interface-id interface
Note
configuration command. To return an interface to its default switchport mode (dynamic auto), use the no
switchport mode interface configuration command. To reset the access mode to the default VLAN for
the switch, use the no switchport access vlan interface configuration command.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. switchport mode access
5. switchport access vlan dynamic
6. end
7. show interfaces interface-id switchport
8. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2156
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.