Displaying Online Diagnostic Tests And Test Results - Cisco 7604 Configuration Manual

Chapter 55 Configuring Generic Online Diagnostics

Displaying Online Diagnostic Tests and Test Results

You can display the online diagnostic tests that are configured and check the results of the tests using
the show commands.
To display the diagnostic tests that are configured, perform this task:
Command
show diagnostic content [module 1]
This example shows how to display the online diagnostics that are configured:
Router# show diagnostic content module 1
Module 1:
Diagnostics test suite attributes:
ID
==== ================================== ============ =================
10) TestBadBpdu ---------------------> M**D****I**
11) TestTrap ------------------------> M**D****I**
12) TestMatch -----------------------> M**D****I**
13) TestCapture ---------------------> M**D****I**
14) TestProtocolMatch ---------------> M**D****I**
15) TestChannel ---------------------> M**D****I**
16) TestFibDevices ------------------> M**N****I**
17) TestIPv4FibShortcut -------------> M**N****I**
18) TestL3Capture2 ------------------> M**N****I**
19) TestIPv6FibShortcut -------------> M**N****I**
20) TestMPLSFibShortcut -------------> M**N****I**
21) TestNATFibShortcut --------------> M**N****I**
22) TestAclPermit -------------------> M**N****I**
23) TestAclDeny ---------------------> M**D****I**
24) TestQoSTcam ---------------------> M**D****I**
25) TestL3VlanMet -------------------> M**N****I**
26) TestIngressSpan -----------------> M**N****I**
27) TestEgressSpan ------------------> M**N****I**
28) TestNetflowInlineRewrite --------> C*PD****I**
OL-4266-08
M/C/* - Minimal bootup level test / Complete bootup level test / NA
B/* - Basic ondemand test / NA
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
E/* - Always enabled monitoring test / NA
A/I - Monitoring is active / Monitoring is inactive
R/* - Power-down line cards and need reset supervisor / NA
K/* - Require resetting the line card after the test has completed / NA
Test Name
1) TestScratchRegister -------------> ***N****A**
2) TestSPRPInbandPing --------------> ***N****A**
3) TestTransceiverIntegrity --------> **PD****I**
4) TestActiveToStandbyLoopback -----> M*PDS***I**
5) TestLoopback --------------------> M*PD****I**
6) TestNewLearn --------------------> M**N****I**
7) TestIndexLearn ------------------> M**N****I**
8) TestDontLearn -------------------> M**N****I**
9) TestConditionalLearn ------------> M**N****I**
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Displays the online diagnostics that are configured.
Testing Interval
Attributes (day hh:mm:ss.ms)
000 00:00:30.00
000 00:00:15.00
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
not configured
Running Online Diagnostic Tests
55-7