Tool Data Oem - Siemens SINUMERIK 840D sl Operating Manual

Manage tools

13.7 Tool data OEM

Multiple load points
If you have configured several loading points for a magazine, then the "Load Point Selection"
window appears after pressing the "Load" softkey.
Select the required load point and confirm with the "OK" softkey.
13.7 Tool data OEM
You have the option of configuring the list according to your requirements.
Depending on the machine configuration, grinding-specific parameters are displayed in the list
with OEM tool data.
Grinding tool-specific parameters
Column heading
Min. radius
Actual radius
Min. width
Actual width
Maximum speed
Max. peripheral velocity
Wheel angle
Spindle number
Param. rad.calc.
Chaining rule
280
Meaning
Minimum radius
Limit value for the radius of the grinding wheel to monitor the geometry.
Actual radius
Displays the sum of the geometry value, wear value and, if set, the base
dimension.
Minimum wheel width
Limit value for the width of the grinding wheel to monitor the geometry.
Actual wheel width
The width of the grinding wheel measured, for example, after the dressing.
Specifies the maximum speed
Specifies the maximum peripheral velocity
Specifies the angle of inclined grinding wheel
Specifies the programmed spindle number (e.g. grinding wheel peripheral
velocity) and spindle to be monitored (e.g. wheel radius and width).
Selects the parameter to calculate the radius
● Length X
● Length Y
● Length Z
● Radius
This parameter defines which tool parameters of tool cutting edge 2 (D2)
and tool cutting edge 1 (D1) have to be chained to one another. When the
value of a chained parameter is modified, then the other cutting edge is
automatically used when chaining the parameter.
Operating Manual, 05/2017, A5E40869190
Grinding