Procedure
...
4.5.9
Deleting seat-related fine offsets
You have the option of deleting seat-dependent fine offsets after you have changed a tool.
The values that have been entered are then set to zero.
Procedure
Grinding
Operating Manual, 05/2017, A5E40869190
1.
Select the "Parameter" operating area.
2.
Press the "Work offset" softkey.
3.
Press the "Overview", "Basis" or "G54...G599" softkey.
4.
Press the "Details" softkey.
5.
Position the cursor on the work offset you would like to delete.
6.
Press the "Clear offset" softkey.
A confirmation prompt is displayed as to whether you really want to delete
the work offset.
7.
Press the "OK" softkey to confirm that you wish to delete the work offset.
1.
Select the "Parameter" operating area.
2.
Press the "Work offset" softkey.
3.
Press softkey "GFrame1...G-Frame2".
Note:
The labeling of the softkeys for the seat-related fine offsets varies, i.e. the
seat-dependent work offsets configured at the machine are displayed
(examples: GFRAME1...GFRAME1, GFRAME1...GFRAME2,
GFRAME1...GFRAME100).
Here, please observe the information provided by the machine manufac‐
turer.
4.
In the "Work offset - GFrame1 ... GFrame2" window in the table, set all
values of the seat-related fine offsets to zero.
Setting up the machine
4.5 Zero offsets
83