- OR
Note
Display of the traversing paths
● If you switch-off simultaneous recording during machining and then switch-on the function
again at a later time, then the traversing paths generated in the intermediate time will not
be displayed.
7.5
Program control during simulation
7.5.1
Changing the feedrate
You have the capability of changing the feedrate at any time during the simulation.
You track the changes in the status bar.
Note
If you are working with the "Simultaneous recording" function, you use the rotary switch
(override) on the control panel.
Procedure
Grinding
Operating Manual, 05/2017, A5E40869190
4.
Press the "Sim. rec." softkey again to stop the recording.
1.
Simulation is started.
2.
Press the "Program control" softkey.
3.
Press the "Override +" or "Override -" softkey to increase or decrease the
feedrate by 5%, respectively.
- OR -
Press the "100% override" softkey to set the feedrate to 100%.
- OR -
Press the "<<" softkey to return to the main screen and perform the sim‐
ulation with changed feedrate.
Simulating machining
7.5 Program control during simulation
183