Starting Simultaneous Recording; Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining

7.4 Simultaneous recording during machining of the workpiece

7.3.2

Starting simultaneous recording

Procedure
- OR -
- OR -
7.4 Simultaneous recording during machining of the workpiece
If the view of the work space is blocked by coolant, for example, while the workpiece is being
machined, you can also track the program execution.
Procedure
- OR
182
1. Load a program in the "AUTO" mode.
2. Press the "Prog. ctrl." softkey and activate the checkboxes "PRT no axis
movement" and "DRY run feedrate".
The program is executed without axis movement. The programmed fee‐
drate is replaced by a dry run feedrate.
3. Press the "Sim. rec." softkey.
4. Press the <CYCLE START> key.
The program execution is displayed graphically.
5. Press the "Sim. rec." softkey again to stop the recording.
Software option
You require the option "Simultaneous recording (real-time simulation)" for si‐
multaneous recording.
1. Load a program in the "AUTO" mode.
2. Press the "Sim. rec." softkey.
3. Press the <CYCLE START> key.
The machining of the workpiece is started and graphically displayed.
Operating Manual, 05/2017, A5E40869190
Grinding