Displaying The Current Program Block; Current Block Display - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece

6.4 Displaying the current program block

6.4 Displaying the current program block
6.4.1

Current block display

The window of the current block display shows the program blocks currently being executed.
Display of current program
The following information is displayed in the running program:
● The workpiece name or program name is entered in the header line.
● The program block which is just being processed appears colored.
Display of the machining times
If you set that the machining times are to be recorded in the settings for automatic mode, the
measured times are shown at the end of the line as follows:
Display
Light green background Measured machining time of the program block (automatic mode)
Green background
Light blue background
Blue background
Yellow background
120
5. Press the <SINGLE BLOCK> key again, if the machining is not supposed
to run block-by-block.
The key is deselected again.
If you now press the <CYCLE START> key again, the program is execu‐
ted to the end without interruption.
Meaning
Measured machining time of the program block (automatic mode)
Estimated machining time of the program block (simulation)
Estimated machining time of the program block (simulation)
Wait time (automatic mode or simulation)
Operating Manual, 05/2017, A5E40869190
Grinding