Default Settings For Manual Mode - Siemens SINUMERIK 840D sl Operating Manual

The feedrate / rapid traverse override is active during traversing.
Procedure
5.5

Default settings for manual mode

Specify the configurations for the manual mode in the "Settings for manual operation" window.
Default settings
Settings
Type of feedrate
Setup feedrate G94
Setup feedrate G95
Variable increment
Spindle speed
Grinding
Operating Manual, 05/2017, A5E40869190
1. If required, select a tool.
2. Select the "JOG" operating mode.
3. Press the "Positions" softkey.
4. Enter the target position or target angle for the axis or axes to be traversed.
5. Specify the desired value for the feedrate F.
- OR -
Press the "Rapid traverse" softkey.
The rapid traverse is displayed in field "F".
6. Press the <CYCLE START> key.
The axis is traversed to the specified target position.
If target positions were specified for several axes, the axes are traversed
simultaneously.
Meaning
Here, you select the type of feedrate.
● G94: Axis feedrate/linear feedrate
● G95: Revolutional feedrate
Enter the desired feedrate in mm/min.
Enter the desired feedrate in mm/rev.
For variable increments, enter the desired increment when traversing axes.
Here, enter the desired spindle speed in rpm.
Working in the manual mode
5.5 Default settings for manual mode
115