C1
1 Brief description
Module objective:
Upon completion of this module you can use the RCS802 Data transfer tool to transfer data to/from
the control.
Module description:
NC programs can be written internally (Direct to the NC memory) or externally (computer / laptop).
The programs which are created can be transferred using the RCS802 tool to/from the control.
Module content:
SINUMERIK 802D sl Operating and Service Training Manual
RCS802 Data Transfer Tool
•
Principle of operation
•
Transfer data from the controller
•
Transfer data to the controller
Principle of operation
Transfer data from the
controller
Transfer data to the
controller
Page 1
Section 2
Section 3
Section 4
C1
C1