Selecting A Program - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece

6.2 Selecting a program

Stopping machining
Canceling machining
6.2 Selecting a program
Procedure
118
Press the <CYCLE STOP> key.
Machining stops immediately, individual blocks do not finish execution.
At the next start, execution is resumed at the same location where it
stopped.
Press the <RESET> key.
Execution of the program is interrupted. On the next start, machining will
start from the beginning.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Select the "Program Manager" operating area.
The directory overview is opened.
2. Select the location where the program is archived (e.g. "NC")
3. Place the cursor on the directory containing the program that you want
to select.
4. Press the <INPUT> key.
- OR -
Press the <Right cursor> key.
The directory contents are displayed.
5. Place the cursor on the desired program.
6. Press the "Select" softkey.
When the program has been successfully selected, an automatic change‐
over to the "Machine" operating area occurs.
Operating Manual, 05/2017, A5E40869190
Grinding