Displaying Status Of Synchronized Actions - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece

6.15 Displaying status of synchronized actions

6.15 Displaying status of synchronized actions
You can display status information for diagnosing synchronized actions in the "Synchronized
Actions" window.
You get a list with all currently active synchronized actions.
In this list, the synchronized action programming is displayed in the same form as in the part
program.
References
Programming Guide Job Planning (PGA) Chapter: Motion-synchronous actions
Status of synchronized actions
You can see the status of the synchronized actions in the "Status" column.
● Waiting
● Active
● Blocked
Non-modal synchronized actions can only be identified by their status display. They are only
displayed during execution.
Synchronization types
Synchronization types
ID=n
IDS=n
Without ID/IDS
170
3. Press the ">>" and "Superimposition" softkeys.
The "Superimposition" window opens.
4. Enter the required new minimum and maximum values for superimposi‐
tion and press the <INPUT> key to confirm your entries.
Note:
You can only change the superimposition values in "JOG" mode.
5. Press the "Superimposition" softkey again to hide the window.
Meaning
Modal synchronized actions in the automatic mode up to the end of pro‐
gram, local to program; n = 1... 254
Static synchronized actions, modally effective in every operating type, also
beyond the end of program; n = 1... 254
Non-modal synchronized actions in the automatic mode
Operating Manual, 05/2017, A5E40869190
Grinding