Simultaneous Recording Before Machining Of The Workpiece; Overview - Siemens SINUMERIK 840D sl Operating Manual

Note
Operating area switchover
The simulation is exited if you switch into another operating area. If you restart the simulation,
then this starts again at the beginning of the program.
7.3

Simultaneous recording before machining of the workpiece

7.3.1

Overview

Before machining the workpiece on the machine, you can graphically display the execution of
the program on the screen to monitor the result of the programming.
You can replace the programmed feedrate with a dry run feedrate to influence the speed of
execution and select the program test to disable axis motion.
If you would like to view the current program blocks again instead of the graphical display, you
can switch to the program view.
Grinding
Operating Manual, 05/2017, A5E40869190
7.3 Simultaneous recording before machining of the workpiece
5. Press "Start" softkey.
The program execution is displayed graphically on the screen. The ma‐
chine axes do not move.
6. To stop simulation, press the "Stop" softkey.
- OR -
Press the "Reset" softkey to cancel the simulation.
7. Press the "Start" softkey to restart or continue the simulation.
Software option
You require the option "Simultaneous recording (real-time simulation)" for the
simultaneous recording.
Simulating machining
181