Contour Call (Cycle62); Function - Siemens SINUMERIK 840D sl Operating Manual

Programming technology functions
9.1 Programming contours
Procedure for deleting a contour element
Note
Ensure that the complete contour and the transition to the following element remain.
9.1.5

Contour call (CYCLE62)

9.1.5.1

Function

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
The contour is in the calling main program.
2. Labels
The contour is in the calling main program and is limited by the labels that have been
entered.
210
3. With the cursor, select the program block where you want to change the
contour. Open the geometry processor.
The individual contour elements are listed.
4. Position the cursor at the position where a contour element is to be in‐
serted or changed.
5. Select the desired contour element with the cursor.
6. Enter the parameters in the input screen or delete the element and select
a new element.
7. Press the "Accept" softkey.
The desired contour element is inserted in the contour or changed.
1. Open the part program to be machined.
2. Open the contour.
3. Position the cursor on the contour element that you want to delete.
4. Press the "Delete element" softkey.
5. Press the "Delete" softkey.
Operating Manual, 05/2017, A5E40869190
Grinding