Managing A Tool In A File - Siemens SINUMERIK 840D sl Operating Manual

Manage tools
13.5 Tool list
13.5.10

Managing a tool in a file

If, in the tool list settings, the "Permit tool in/out file" option is activated, then an additional entry
is available in the list of favorites.
Figure 13-9
Creating a new tool from file
274
New tool from file in the list of favorites
1. The tool list is opened.
2. Place the cursor in the tool list at the position where the new tool should
be created.
To do this, you can select an empty magazine location or the NC tool
memory outside of the magazine.
You may also position the cursor on an existing tool in the area of the NC
tool memory. Data from the displayed tool will not be overwritten.
3. Press the "New tool" softkey.
The "New Tool - Favorites" window is opened.
4. Position the cursor on the entry "Tool from file" and press the "OK" softkey.
The "Load tool data" window opens.
5. Navigate to the required file and press the "OK" softkey.
The tool data is read from the file and is displayed in the "New tool from
file" window with the tool type, tool name and possibly with certain pa‐
rameters.
6. Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cursor is
located on an empty magazine location in the tool list, then the tool is
loaded to this magazine location.
Operating Manual, 05/2017, A5E40869190
Grinding