Siemens SINUMERIK 840D sl Operating Manual page 263

Column heading
Length X or length Z
- Cylindrical grinding
Length Y or length Z
- Surface grinding
Cutting edge radius
Ø
Outer Ø
Further parameters
If you have set up unique cutting edge numbers, these are displayed in the first column.
Column heading
D no.
SN
EC
You use the configuration file to specify the selection of parameters in the list.
References
Information on the configuration and setting up of the tool list can be found in the following
references:
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Icons in the tool list
Icon/
Marking
Tool type
Red cross
Yellow triangle pointing down‐
ward
Yellow triangle pointing up‐
ward
Grinding
Operating Manual, 05/2017, A5E40869190
Meaning
Tool length
Geometry data length X or length Z
Tool length
Geometry data length Y or length Z
Tool radius (for grinding wheel - type 400, type 410; dresser - type 490,
dressing roller - type 495, dressing wheel - type 497)
Tool diameter
(for 3D-probe - type 710; edge-probe - type 711; mono-probe - type 712; L-
probe - type 713; calibration tool - type 725)
Outer diameter
(for star-type probe - type 714)
Meaning
Unique cutting edge number
Cutting edge number
Setup offsets
Display of the existing setup offsets
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Meaning
The tool is disabled.
The prewarning limit has been reached.
The tool is in a special state.
Place the cursor on the marked tool. A tool tip will pro‐
vide a brief description.
Manage tools
13.5 Tool list
263