Multicast protocol configuration using the ACLI
Enabling multicasting on a brouter port
Configure multicasting on a brouter port to enable MLD on the port.
Prerequisites
You must log on to the Interface Configuration mode in the ACLI.
Procedure steps
Enable multicasting by using the following command:
ipv6 interface multicast-routing [reachable-time <value>]
[retransmit-timer <value>]
Variable definitions
Use the data in the following table to use the ipv6 interface multicast-routing
command.
reachable-time <value>
retransmit-timer <value>
Configuring MLD on a brouter port
Configure MLD on a brouter port to customize the configuration.
304
Configuration — IPv6 Routing
Variable
Value
Configures the reachable time, in
milliseconds, for the interface. The range is
–03600000.
Configures the time between attempts to
transmit multicast packets, in milliseconds,
for the interface. The range is 0–3600000.
November 2010