Ospf Parameters Configured For Vlans - Avaya ERS 8800 series Configuration Manual

CLI show commands
Figure 43: show isv6 ospf neighbor command output

OSPF parameters configured for VLANs

Use the show vlan info ospf command to display OSPF parameters configured for all
VLANs or a specified VLAN. The syntax for this command is as follows.
show vlan info ospf [ <vid> ] [port <value> ]
The following table explains the parameters for this command.
Table 39: Command parameters
port <value>
vid
Figure 44: show vlan info ospf command output
command.
394 Configuration — IPv6 Routing
Parameter Description
Specifies the port or range of ports
configured in the format slot/port.
Specifies a unique integer value in the range
1–4094 that identifies the VLAN to configure.
on page 395 shows sample output for this
November 2010