Creating An Ipv4 Brouter Port On The Source Device; Creating An Ipv6 Vlan With Ports On The Remote Device; Creating An Ipv4 Brouter Port On The Destination Device - Avaya ERS 8800 series Configuration Manual

IPv6 CLI configuration
3. Assign an IPv6 address to the to the VLAN by using the following command:
4. Enable the new VLAN by using the following command:

Creating an IPv4 brouter port on the source device

Procedure steps
1. Create a brouter port with an IPv4 address by using the following command:
2. Enable OSPF on the port by using the following command:
3. Enable OSPF on the device by using the following command:

Creating an IPv6 VLAN with ports on the remote device

Configure the IPv6 VLAN with ports (VLAN 40 in the figure) on the destination device, or 8600.
Procedure steps
1. Create a VLAN by using the following command:
2. Add ports to the VLAN by using the following command:
3. Assign an IPv6 address to the to the VLAN by using the following command:
4. Enable the new VLAN by using the following command:

Creating an IPv4 brouter port on the destination device

Create an IPv4 brouter port on the destination device.
374 Configuration — IPv6 Routing
config vlan 10 ports add 3/1
config vlan 10 ipv6 create addr 4000::1/120
config vlan 10 ipv6 admin enable
config ethernet 3/30 ip create 172.21.80.1/24 1000
config ethernet 3/30 ip ospf enable
config ip ospf enable
config vlan 40 create byport 1
config vlan 40 ports add 3/2
config vlan 40 ipv6 create addr 4000::2/120
config vlan 40 ipv6 admin enable
November 2010