Enabling Multicasting On A Brouter Port - Avaya ERS 8800 series Configuration Manual

config vlan <vid> ipv6 mld
Variable definitions
Use the data in the following table to use the config vlan ipv6 mld command.
info
last-memb-query-int <seconds>
query-interval <seconds>
query-maxresp <1seconds>
robustval <integer>
version <1|2>
<vid>

Enabling multicasting on a brouter port

Configure multicasting on a brouter port to enable MLD on the port.
Procedure steps
Enable multicasting by using the following command:
config ethernet <ports> ipv6 mcast <enable|disable>
Variable definitions
Use the data in the following table to use the config ethernet ipv6 mcast command.
Configuration — IPv6 Routing
Variable
Displays the current VLAN MLD configuration setting.
Configures the query interval time in 1/10 of a second
for the last member.
seconds is in the range 0–65535.
Configures the query interval time in 1/10 of a second.
seconds is in the range 0–65535.
The maximum query response time advertised in MLD
queries on this interface.
seconds is in the range 0–65535.
Configures the robustness value.
integer is in the range 0–65535.
Configures the version of MLD to version 1 or version
2.
Specifies a VLAN ID in the range of 1–4094.
Enabling multicasting on a brouter port
Value
November 2010 297