Configuring A Management Route - Avaya ERS 8800 series Configuration Manual

Basic IPv6 configuration using the CLI
config sys net6-mgmt ipv6 add <IPv6 address/prefix length> cpu-
slot <slot-id>
Variable definitions
Use the data in the following table to use the config sys net6-mgmt ipv6 add
command.
<IPv6 address/prefix length>
<slot-id>

Configuring a management route

Configure a management route to establish communication between networks.
Procedure steps
Configure the management route by using the following command:
config sys net6-mgmt route add <network IPv6 address> <network gateway>
Variable definitions
Use the data in the following table to use the config sys net6-mgmt route add
command.
network gateway
network IPv6 address
98 Configuration — IPv6 Routing
Variable
Variable
Value
Specifies the IPv6 address and prefix length
to assign to the port.
Specifies the slot number where the port is
located. If a slot ID is not specified, the
address is configured for the current SF/
CPU.
Value
Specifies the IPv6 address of the gateway.
Specifies the IPv6 address of the network to
add.
November 2010