Neighbor Cache - Avaya ERS 8800 series Configuration Manual

Figure 54: show ipv6 mld interface

Neighbor cache

Use the show ipv6 neighbor command to view entries in the neighbor cache. The syntax
for this command is as follows.
show ipv6 neighbor [<ipv6addr>] [type {other|dynamic|static|local}]
[interface <interface-type> <interface-id>]
The following table explains the parameters for this command.
Table 50: Command parameters
interface-id
interface-type
type
Configuration — IPv6 Routing
Parameter Description
Specifies the interface ID.
Specifies the type of interface if you want to
limit the output. The options are fastEthernet,
gigabitEthernet, or vlan.
Specifies the type of mapping as one of the
following:
• other
• dynamic
• static
• local
Neighbor cache
November 2010 407