show ipv6 vrrp
clear ipv6
Configuring VRRP on a port
Use the following procedure to configure VRRP on a port.
Procedures steps
1. To configure VRRP on a port, enter: config ethernet <ports> ipv6 vrrp
2. To confirm your configuration, enter: config ethernet <ports> ipv6 vrrp
Configuration — IPv6 Routing
Command
<vrid>
<vrid> info
Parameter
critical-ipv6 <ipaddr>
critical-ipv6-enable <enable|disable>
delete [addr <addr>] [all]
disable
enable
fast-adv-enable <enable|disable>
fast-adv-int <milliseconds>
holddown-timer <seconds>
priority <prio>
global-settings
info [vrid <value>] [link-local <value>]
show-all
stats [vrid <value>] [link-local <value>]
global-stats
ports <ports> vrid <value>
vlan <vid> vrid <value>
Configuring VRRP on a port
November 2010
227