Chapter 12: Ipv6 Dhcp Relay Configuration Using The Cli - Avaya ERS 8800 series Configuration Manual

Chapter 12: IPv6 DHCP Relay configuration
Dynamic Host Configuration Protocol (DHCP) provides host configuration information to the workstations
dynamically. Use the DHCP relay commands to set DHCP relay behavior on a port or on a VLAN.
This section describes the CLI commands for IPv6 DHCP Relay configuration functions in the Avaya
Ethernet Routing Switch 8800/8600.
To configure DHCP Relay, you can use the config ipv6 dhcp-relay command, which allows you to specify
the IP address of the port or VLAN to use as a relay agent, or use the config {vlan <vid> |
ethernet <ports>} ipv6 dhcp-relay command to explicitly specify the port or VLAN to use as
the relay agent.
IPv6 DHCP relay configuration navigation
• Job aid: Roadmap of IPv6 DHCP Relay CLI commands
• Configuring an IPv6 DHCP relay interface
• Configuring IPv6 DHCP relay on a port or VLAN
• Showing IPv6 DHCP relay information
• Showing IPv6 DHCP relay information for a port or VLAN
Job aid: Roadmap of IPv6 DHCP Relay CLI commands
The following table lists the IPv6 DHCP Relay commands and their parameters that you use
to complete the procedures in this section.
Table 14: IPv6 DHCP Relay configuration commands
config ipv6 dhcp-relay
Configuration — IPv6 Routing
using the CLI
Command
on page 199
on page 200
on page 202
on page 203
on page 204
Parameter
info
create-fwd-path agent <value> server
<value> [state <value>]
November 2010 199