Creating A Template For User-Created Patterns - Avaya ERS 8800 series Configuration Manual

ip <ip-attributes>
ipv6 <ipv6-attributes>
name <value>
protocol <protocol-attributes>

Creating a template for user-created patterns

Create a template for patterns within an ACT. You can associate a maximum of three patterns
with an ACT.
Procedure steps
Create a template by using the following command:
config filter act <act-id> pattern <pattern-name>
Variable definitions
Use the data in the following table to use the config filter act pattern command.
Variable
act-id
add <base> <offset>
<length>
Configuration — IPv6 Routing
Variable
Specifies an ACT ID in the range of 1–4096.
Adds a template for patterns you create. Options include:
Creating a template for user-created patterns
Specifies the permitted IP attributes for the ACT
template. The list of allowed attributes must be
separated by commas and includes,
[none | srcIp, dstIp, ipFragFlag, ipOptions,
ipProtoType, dscp].
Specifies the permitted IPv6 for the ACT template. The
list of allowed attributes must be separated by
commas and includes,
[none | srcIpv6, dstIpv6, nextHdr]
Specifies a name for the ACT. <value> is an optional
parameter that specifies a name for the ACT using 0–
32 characters.
Specifies the permitted protocol attributes for the ACT
template. The list of allowed attributes must be
separated by commas and includes,
[none | tcpSrcPort, udpSrcPort, tcpDstPort,
udpDstPort, tcpFlags, icmpMsgFlags]
Value
Value
November 2010 325