Configuring Ospf Direct Redistribution - Avaya ERS 8800 series Configuration Manual

poll-interval <seconds>
priority <priority>
retransmit-interval <seconds>
transit-delay <seconds>

Configuring OSPF direct redistribution

Enable or disable direct redistribution to obtain information about redistributing IPv6 direct
routes into an OSPFv3 routing domain.
Procedure steps
Configure OSPF direct redistribution by using the following command:
config ipv6 ospf redistribute direct
Variable definitions
Use the data in the following table to use the config ipv6 ospf redistribute direct
command.
Configuration — IPv6 Routing
Variable
Configures the polling interval for the OSPF interface
in seconds.
seconds is between 0–2147483647.
Configures the OSPF priority for the interface during
the election process for the designated router. The
interface with the highest priority number is the
designated router. The interface with the second-
highest priority becomes the backup designated
router. If the priority is 0, the interface cannot become
either the designated router or a backup. The priority
is used only during election of the designated router
and backup designated router.
priority is in the range 0–255. The default is 1.
Configures the retransmit interval for the OSPF
interface, the number of seconds between link-state
advertisement retransmissions.
seconds is an integer between 1–1 800.
Configures the transit delay time for the OSPF
interface, the estimated time in seconds it takes to
transmit a link-state update packet over the interface.
seconds is an integer between 1–1 800.
Configuring OSPF direct redistribution
Value
November 2010 167