Basic IPv6 configuration using the ACLI
Prerequisites
You must log on to the Global Configuration mode in the ACLI.
Procedure steps
Create a VLAN by using the following command:
vlan create <vid> name <value> type <value>
Variable definitions
Use the data in the following table to use the vlan create command.
name <value>
type <value>
122
Configuration — IPv6 Routing
Variable
Value
Configures a name for the VLAN.
Specifies the type of VLAN to create:
• port [<stgId:1-16>|cist|msti <1-15>]
• protocol-ApltkEther2Snap
• protocol-decEther2
• protocol-decOtherEther2
• protocol-ipEther2
• protocol-ipv6Ether2
• protocol-Netbios
• protocol-RarpEther2
• protocol-sna802.2
• protocol-snaEther2
• protocol-Userdef <4096-65534>
• protocol-vinesEther2
• protocol-xnsEther2
• ipsubnet-mstprstp <1-63> <A.B.C.D/0-32>
[color<1-32>]
• port-mstprstp <1-63> <A.B.C.D/0-32>
[color<1-32>] [naap-vlan] [firewall-vlan]
[firewall-peering-vlan]
November 2010