Configuring Acts - Avaya ERS 8800 series Configuration Manual

config filter acl <acl-id> vlan
config filter act <act-id>
config filter act <act-id> pattern <pattern-
name>

Configuring ACTs

Configure an access control template (ACT) to create, delete, apply, and specify attributes.
After you apply the ACT you cannot change the attributes. ACT IDs 4001 to 4096 are reserved
for system-defined ACTs.
System-defined ACTs are available for filters as required.
Important:
An ACT can use IPv4 or IPv6 attributes, but not both. You cannot combine IPv4 and IPv6
attributes in the same ACL.
Procedure steps
Configure an ACT by using the following command:
Configuration — IPv6 Routing
Command Parameter
add <vid> [<vid2-vid3>]
remove <vid> [<vid2-vid3>]
info
create [name <value>]
delete
apply
name <value>
info
arp <arp-attributes>
ip <ip-attributes>
ipv6 <ipv6-attributes>
ethernet <ethernet-attributes>
protocol <protocol-attributes>
add <base> <offset> <length>
name <pattern-name>
info
Configuring ACTs
November 2010 323