IPv6 CLI configuration
4. Create an IPv6 interface on the same VLAN or brouter port where you configured
5. Enable the IPv6 interface.
6. Create an OSPFv3 area by using the following command:
7. Create an OSPFv3 interface.
8. Enable OSPF on the IPv6 interface.
Tunnel configuration between brouter ports
The following figure shows the tunnel configuration between brouter ports.
372
Configuration — IPv6 Routing
config vlan 100 ip ospf enable
Enter the following command for a brouter port:
config ethernet 2/1 ip ospf enable
IPv4.
Enter the following command for a VLAN:
config vlan 100 ipv6 create addr 3001::1/64
Enter the following command for a brouter port:
config ethernet 2/1 ipv6 create addr 3001::1/64 vlan 100
Enter the following command for a VLAN:
config vlan 100 ipv6 admin-status en
Enter the following command for a brouter port:
config ethernet 2/1 ipv6 admin-status en
config ipv6 ospf area 2.2.2.2 create
Enter the following command for a VLAN:
config vlan 100 ipv6 ospf create 2.2.2.2 metric 2
Enter the following command for a brouter port:
config ethernet 2/1 ipv6 ospf create 2.2.2.2 metric 2
Enter the following command for a VLAN:
config vlan 100 ipv6 ospf admin enable
Enter the following command for a brouter port:
config ethernet 2/1 ipv6 ospf admin enable
November 2010