Chapter 19: Ipv6 Rsmlt Configuration Using The Acli - Avaya ERS 8800 series Configuration Manual

Chapter 19: IPv6 RSMLT configuration using
Routed Split MultiLink Trunking (RSMLT) forwards packets in the event of core router failures, thus
minimizing dropped packets during the routing protocol convergence.
To configure IPv6 RSMLT functionality, use the same set of commands as required for IPv4 RSMLT.
RSMLT configuration on a given VLAN simultaneously affects both IPv4 and IPv6. For example, the
following command is used for configuring IPv6 RSMLT on a VLAN:
(config-if)# ip rsmlt
All options apply equally to IPv6 and IPv4 RSMLT.
Note that the preceding command enables IPv6 RSMLT on a VLAN even in the absence of IPv4
configuration on the VLAN.
RSMLT configuration procedures
Refer to the following procedures to configure RSMLT.
RSMLT navigation
• Job aid: Roadmap of IPv6 RSMLT ACLI commands
• Configuring RSMLT on a VLAN
• Showing IP RSMLT information
• Configuring RSMLT-edge
Job aid: Roadmap of IPv6 RSMLT ACLI commands
The following table lists the commands and their parameters that you use to complete the
procedures in this section.
Configuration — IPv6 Routing
the ACLI
on page 264
on page 265
on page 266
on page 263
November 2010 263