Enabling A Vlan For Multicast Routing; Configuring Mld On A Vlan - Avaya ERS 8800 series Configuration Manual

Multicast protocol configuration using the CLI
Procedure steps
Enable the multicast router by using the following command:
config ipv6 mcast <enable|disable>

Enabling a VLAN for multicast routing

Configure a VLAN for multicast traffic to enable MLD on the VLAN.
Procedure steps
Enable a VLAN for multicast routing by using the following command:
config vlan <vid> ipv6 mcast <enable|disable>
Variable definitions
Use the data in the following table to use the config vlan ipv6 mcast <enable|
disable> command.
<vid>

Configuring MLD on a VLAN

Configure MLD on a VLAN to customize the configuration.
Procedure steps
Configure MLD by using the following command:
296 Configuration — IPv6 Routing
Variable Value
Specifies a VLAN ID in the range of 1–4094.
November 2010