Avaya ERS 8800 series Configuration Manual page 303

Prerequisites
You must log on to the VLAN Interface Configuration mode in the ACLI.
Procedure steps
Configure MLD by using the following command:
ipv6 mld [last-memb-query-int <value>] [query-interval <value>]
[query-max-response-time <value>] [robustval <value>] [version
<1|2>]
Variable definitions
Use the data in the following table to use the ipv6 mld command.
last-memb-query-int <value>
query-interval <value>
query-max-response-time <value> Configures the query interval time in 1/10 of a second
robustval <value>
version <1|2>
Configuration — IPv6 Routing
Variable
Configures the query interval time in 1/10 of a second
for the last member.
value is in the range 0–65535.
The default value is 1.
Configures the maximum query response time
advertised in MLD queries on this interface.
value is in the range 0–65535.
The default value is 125.
for the last member.
value is in the range 0–65535.
The default value is 10.
Configures the robustness value.
value is in the range 0–65535.
The default value is 2.
Configures the version of MLD to version 1 or version
2.
The default value is 1.
Configuring MLD on a VLAN
Value
November 2010 303