Avaya ERS 8800 series Configuration Manual page 192

IPv6 routing configuration using the ACLI
network <value>
poll-interval <seconds>
priority <value>
retransmit-interval <seconds>
transit-delay <seconds>
192 Configuration — IPv6 Routing
Variable
Configures the type of interface:
• eth—broadcast
• nbma—NBMA
• p2mp—point-to-multipoint
• p2p—point-to-point
Configures the polling interval for the OSPF interface
in seconds.
seconds is from 0–2147483647.
To configure this option to the default value, use the
default operator with the command.
The default value is 120.
Configures the OSPF priority for the interface during
the election process for the designated router. The
interface with the highest priority number is the
designated router. The interface with the second-
highest priority becomes the backup designated
router. If the priority is 0, the interface cannot become
either the designated router or a backup. The priority
is used only during election of the designated router
and backup designated router.
value is in the range 0–255. The default is 1.
To configure this option to the default value, use the
default operator with the command.
Configures the retransmit interval for the OSPF
interface; the number of seconds between link-state
advertisement retransmissions.
seconds is an integer from 1–1800.
To configure this option to the default value, use the
default operator with the command.
The default value is 5.
Configures the transit delay time for the OSPF
interface, the estimated time in seconds it takes to
transmit a link-state update packet over the interface.
seconds is an integer from 1–1800.
To configure this option to the default value, use the
default operator with the command.
The default value is 1.
Value
November 2010