Configuring Ospf Direct Redistribution - Avaya ERS 8800 series Configuration Manual

IPv6 routing configuration using the ACLI
retransmit-interval <seconds>
transit-delay <seconds>

Configuring OSPF direct redistribution

Enable or disable direct redistribution to redistribute IPv6 direct routes into an OSPFv3 routing
domain.
Prerequisites
You must log on to the OSPF Router Configuration mode in the ACLI.
Procedure steps
Configure OSPF direct redistribution by using the following command:
188 Configuration — IPv6 Routing
Variable
highest priority becomes the backup designated
router. If the priority is 0, the interface cannot become
either the designated router or a backup. The priority
is used only during election of the designated router
and backup designated router.
value is in the range 0–255. The default is 1.
To set this option to the default value, use the default
operator with the command.
Configures the retransmit interval for the OSPF
interface; the number of seconds between link-state
advertisement retransmissions.
seconds is an integer from 1–1 800.
To configure this option to the default value, use the
default operator with the command.
The default value is 5.
Configures the transit delay time for the OSPF
interface, the estimated time in seconds it takes to
transmit a link-state update packet over the interface.
seconds is an integer from 1–1 800.
To configure this option to the default value, use the
default operator with the command.
The default value is 1.
Value
November 2010