Adding Static Entries To The Neighbor Cache - Avaya ERS 8800 series Configuration Manual

Basic IPv6 configuration using the ACLI
ra-lifetime
rtr-advert-max-interval
rtr-advert-min-interval
send-ra

Adding static entries to the neighbor cache

The neighbor cache contains information about IPv6 neighbors to which the IPv6 device sends
traffic. You can manually add neighbors to the cache.
Prerequisites
You must log on to the Global Configuration mode in the ACLI.
Procedure steps
Add a neighbor by using the following command:
130 Configuration — IPv6 Routing
Variable Value
The default value is false.
Enter the router lifetime included in router
advertisement. Other devices use this information to
determine if the router can be reached. The range is
0 or 4–9000. Use the default operator to configure
this value to the default setting.
The default value is 1800.
Configures the maximum time allowed between
sending unsolicited multicast router advertisements.
The default value is 600.
Configures the minimum time allowed, in seconds
(3–1350), between sending unsolicited multicast
router advertisements from the interface. Use the
default operator to configure this value to the default
setting.
The default value is 200.
Enable or disable periodic router advertisement
messages. Use the no operator to remove this
option. Use the default operator to configure this
value to the default setting.
The default value is true.
November 2010