Configuring Ospf Area Virtual Interfaces - Avaya ERS 8800 series Configuration Manual

IPv6 routing configuration using the ACLI
ipv6 area range <A.B.C.D> <Ipv6 address/prefix> <inter-area-
prefix-link|nssa-extlink> advertise-mode <advertise|not-
advertise>] advertise-metric <0–65535>
Variable definitions
Use the data in the following table to use the ipv6 area range command.
A.B.C.D
advertise-metric <0–65535>
advertise-mode <advertise|no-
advertise>
ipv6addrress/prefix

Configuring OSPF area virtual interfaces

If a remote OSPF ABR uses no connection to the backbone area but needs to be part of the
same routing domain (AS) in which the switch resides, configure an OSPF virtual interface to
the ABR.
You can use any value for the OSPF area name (for example, 1.1.1.1 or 200.200.200.200).
Important:
OSPF behavior is modified according to OSPF standards so that OSPF routes cannot be
learned through an area border router (ABR) unless the router connects to the backbone or
through a virtual link.
184 Configuration — IPv6 Routing
Variable
Specifies the IP address of the area.
Specifies the advertise metric value and LSA type.
The default value is 0.
Specifies the area range advertise mode as
advertise no-advertise
or
The default value is advertise.
Configures the IPv6 address range of an OSPF area.
The string length is 0–255 characters.
Value
.
November 2010