Configuring Vrrp On A Vlan - Avaya ERS 8800 series Configuration Manual

IPv6 VRRP configuration using Enterprise Device Manager
Variable
HoldDownTimer
HoldDownTimeRemainin
g
GlobalIPAddr

Configuring VRRP on a VLAN

Use this procedure to configure VRRP on a VLAN. You can configure VRRP on a VLAN only
if the VLAN is assigned an IP address.
Procedure steps
1. In the navigation tree, open the following folders: Configuration, VLAN.
2. Double-click VLANs.
3. In the Basic tab, select a VLAN.
4. Click IPv6.
5. Select the VRRP tab.
6. Click Insert.
7. Edit the fields as required.
8. Click Insert.
Variable definitions
Use the data in the following table to use configure VRRP on a VLAN.
Variable
IfIndex
InetAddrType
218 Configuration — IPv6 Routing
• none does not override the timer
• preemptHoldDownTimer preempts the timer
Configures the amount of time (in seconds) to wait before
preempting the current VRRP master.
Indicates the amount of time (in seconds) left before the
HoldDownTimer expires.
The global IPv6 address assigned to the virtual router interface.
The index value that uniquely identifies the interface to which
this entry is applicable.
The address type for the VRRP interface. In this case, IPv6.
Value
Value
November 2010