Configuring Port-Based Ospf Neighbor Parameters - Avaya ERS 8800 series Configuration Manual

config ethernet <ports> ipv6 ospf

Configuring port-based OSPF neighbor parameters

Configure port-based OSPFv3 neighbor parameters for specified ports to customize your
OSPF IPv6 configuration.
Important:
Both sides of the OSPF connection must use the same authentication type and key.
Procedure steps
Configure port-base OSPF neighbor parameters by using the following command:
config ethernet <ports> ipv6 ospf nbma-nbr <ipv6address>
You must use an IPv6 link-local address as an NBMA neighbor.
Variable definitions
Use the data in the following table to use the config ethernet ipv6 ospf nbma-nbr
command.
create <priority>
delete
info
ipv6address
ports
priority <priority>
Configuration — IPv6 Routing
Important:
Variable
Configuring port-based OSPF neighbor parameters
Creates a neighbor priority. The range is 0–255. The
default is 1.
Deletes an OSPF NBMA neighbor.
Displays OSPF characteristics on the port.
Specifies the IPv6 address of the neighbor as a string
of 0–43.
Specifies the port or range of ports to configure in the
format slot/port.
Configures the OSPF priority for the interface during
the election process for the designated router. The
interface with the highest priority number is the
designated router. The interface with the second-
highest priority becomes the backup designated
Value
November 2010 171